COVID-19 updates
, , ,
Home | Courses | Design and Size Consumer Gas Installations Skill Set

Design and Size Consumer Gas Installations Skill Set

State ID: GAA87

The designing and sizing of consumer gas installations is a compulsory requirement within the Trade Certificate (Certificate IV in Plumbing) for a plumber in WA.

This course covers the skills and knowledge needed to design, document and draw consumer gas installations under the scope of operations enabled by a G class permit holder in Western Australia.

See entrance requirements for important information about studying this course.

Entrance Requirements

Job opportunities

Study pathway

Entrance Requirements

Students will need extensive gas fitting knowledge at Certificate III level prior to enrolment.

Job opportunities

Delivery location, important dates and study options

All year round

Rockingham - Part Time-Classroom



Where Rockingham
How Part Time
Enquire now
Short courses and skill set courses run subject to demand. Use the course enquiry form at the end of this page to enquire now.

Course enquiry

Please note: Using this form will assist you in requesting further information about a course, and in the case of short courses and skill sets, begin your application to study with us. If you would like to apply for a full or part time course or require further application information, please see the instructions against your preferred delivery location and study mode in the section immediately above this form. 

For short courses and skill sets, your enquiry using this form can be the start of your application, or you can ask for more information if you don't feel ready.
Page last updated October 22, 2019